Basic composition
Two component epoxy resin topcoat; It is refined from epoxy resin, coloring pigments, physical pigments, solvents, additives, and other polyamide curing agents.
Main characteristics
Heat resistance: The paint film is self drying at room temperature and has excellent physical and chemical properties. The epoxy topcoat coating has a variety of colors and excellent decorative properties. The paint film has strong corrosion resistance and solvent resistance.
Mechanical properties: excellent adhesion, wear resistance, impact resistance, and hardness.
Product Usage
Epoxy topcoat is mainly used for anti-corrosion coating in indoor and basement environments without direct sunlight, such as indoor steel structures, water treatment equipment, oil storage, gas, water tanks, and other interior walls. It is particularly suitable for humid, humid, alkaline, and other environments.
technical requirement
project
index
State in container
No hard lumps after mixing
Brushworthiness
After brushing, there are no brush marks and no impact on the substrate
adhesion
Level 0
impact strength 
50kg · cm
Covering power
70g/㎡
Water resistance (30 days)
No foaming, no peeling
Acid resistance 10% H2SO4 solution
10 days without wrinkling, blistering, or peeling
Alkali resistance, 10% NaOH solution
10 days without wrinkling, blistering, or peeling
Construction reference
Construction conditions:
Environmental temperature: 5 ℃~40 ℃;
Relative humidity: 25%~85%;
Substrate temperature: 3 ℃ above dew point.
Construction technology:
Recommended thickness: Wet film: 80 μ M; Dry film: 50 μ M;
• Diluent: epoxy diluent;
Applicable period: (25 ± 2 ℃) 8 hours
1. Weigh the two components proportionally, slowly pour the curing agent into the main paint, and stir evenly. Allow to stand for 10 to 30 minutes (maturation stage). The prepared paint is used up within its shelf life.
2. Add diluents to adjust the construction viscosity based on the adopted construction method, paint type, etc.
Construction method:
project
High pressure airless spraying
Maximum dilution amount
0-15%
Orifice
0.53-0.66mm
Ejection pressure
17-20MPa
Transportation and storage
1. When transporting products, they should be protected from rain and sunlight, avoid collisions, and comply with relevant regulations of the transportation department.
2. The product should be stored in a cool and ventilated place, protected from direct sunlight, and isolated from ignition sources, away from heat sources in the warehouse. The storage period is one year.